 Rogue Engineering E46 Rear Spring Perch Reinforcement
Protect your E46!
For those that use coilovers on E46
vehicles, prevent damage to your rear spring perch with the Rogue
Engineering E46 Rear Spring Perch reinforcement. This ONLY applies
to E46 vehicles (not E36) because of the cast aluminum construction of the
lower arm. The use of coilover rear spring adjusters concentrates
the load onto the center of the arm, causing it to crack or break. Damage to
this lower arm can cost over $500! This requires replacement of the
arm (approximately $250 from the dealer), labor (about 2
hours) and alignment.
TC Kline Rear Adjuster
GC Adjuster
Easy Solution to an Avoidable
Problem
Our stainless reinforcement prevents this from happening. By
spreading out the load, it emulates the factory rubber pad by dispersing
the load over a larger area preventing damage. Unlike the factory
rubber pad, our reinforcement is only 1/8" thick adding very little
additional thickness.
Made here in the USA, our plates are
constructed from CNC plasma cut stainless steel. They will never rust
and requires no maintenance. Just install and go!
Easy Installation |
Installed! |
Sold by the pair. |
