Rogue Engineering Alloy RACE Lugnuts

These superlight alloy RACE lugnuts are made for those using studs, to save some precious rotational weight!  These are for those who only use and expect the very most from their vehicles.

Thoughtfully machined with a 19mm hex (BMW uses a standard 17mm), these allow for a stronger design allowing for thicker walls.

Specifications

• Entirely CNC machined from forged 7075 T-6 aluminum/magnesium.
• M12x1.5 thread, 19mm hex, 35mm total height, open design
• Black anodized finish, will not rust like steel nuts
• 60° Conical Seat
• 40% lighter than steel!  Save more than a 1/2 pound of rotating weight from your wheels!

Tech Information

Although these are very strong, it is imperative that the socket used while installing these have FULL engagement when installing and removing the nuts.  Failure to do so can lead to premature wear and failure.

Do NOT use any lubricants (grease, anti-seize) on ANY part of the lugnut (or stud).  Using any lubricant can give false torque readings when using a torque wrench during installation.

Note that the socket does not go completely down on the hex portion.

Some wheel bolt/nut sockets have a "insert" preventing full engagement.

Poking out the insert allows for full engagement.

Fully engage nut allows for full and accurate torque for installation or removal.