Questions? Give us a call at 201-783-8600

Rogue Engineering Brake Caliper Guide Bushing Set

Your Price: $40.00
Part Number:RE.038

This is the best brake upgrade you can get for your BMW!  Whereas hardcore track and racecar users may use a BBK on the front, this is an excellent compliment on the factory rear calipers.  For HPDE users, installing these on the front and rear (with track pads, stainless lines and the proper fluid) is also an excellent upgrade.

Our brass bushings eliminate caliper twisting caused by the rubber guide pin bushings. These precision machined brass guide bushings allow for the caliper to squeeze evenly on both sides of the brake rotor, resulting in much longer pad life and more consistent brake pedal feel. These are a must if you race your BMW. Fits all front and rear BMW factory sliding single calipers made by ATE. 

Be sure to regularly clean and grease for best results, otherwise they can bind if left unattended.

Contains: (4) Brass Guide Bushings, (4) Snap Rings. One set required per axle.

Fits all front and rear BMW factory sliding single calipers made by ATE.  

Will NOT fit the following calipers:

  • E30 318/325 Girling front calipers
  • E28 M5 front calipers
  • E24 M6, 850csi front calipers
  • E9x 335d, 335i, 335is, 335xi & M3 front calipers
  • E82 1M & 135i optional front 6-piston calipers,
  • E60 525i, 525xi, 528i, 528xi, 530i, 530xi, 535i,535xi, 545i, 550i or M5 front calipers.

Related Items

Recently Viewed Items